What Should You Do When the ABS Light Turns On?

You'll know there's a problem when the ABS light comes on. The ABS light is fixed based on the kind of ABS problem.

When slowing down during a corner, the car may behave oddly. Furthermore, even though the steering wheel is completely turned into the bend, the car speeds beyond the downward curve and continues straight.

The ABS runs a self-test when you enter the car key and turn on the ignition. If there is insufficient data during the self-test or if the hydraulic valve or pump malfunctions, the ABS light will illuminate. The good operation of the classic braking system is relied upon by ABS. You may still brake normally without the ABS if the remainder of the braking system is in excellent operating order.

If the ABS light is on during a MOT test, this will result in a test failure. Go online and check MOT history of your vehicle to confirm if the ABS system was a reason for failure in the past. If yes, see if you have any garage invoice to confirm what repair work was completed to fix the issue.

This is a severe problem that must be addressed as soon as possible. Look for a trustworthy car garage in Reading and make an appointment with a skilled technician to diagnose and repair the problem.

If an ABS light is lighted, the following might be probable causes and actions to take:

1. Replace the blown ABS fuse - The ABS fuse should be changed if it has blown. The ABS fuse panel is usually found beneath the dashboard. Look through your owner’s handbook to confirm the location of the fuse box the correct type of fuse that needs to be replaced.

2. Repair/replace a leaking ABS pump - Only replace the module once you've determined it's leaking. The pump is on the driver's side. Remove the black wire from the bleed abs module to the driver's side fender and unbolt it. Using a wire brush, clean the bolt and lug. To make the pieces glisten, remove all of the dust from them. Apply Di-grease to the lug and bolt on both sides, as well as the bolt hole. On the bolt and lug surfaces, as well as the wire housing, more Di-grease should be applied. Make careful to lubricate any metal surfaces. If you are not confident in repairing the leaking ABS pump, book your car in with a garage in Reading and let a professional car mechanic repair the problem.

3. Replace the ABS computer module - The ABS controller keeps track of the wheels' rotational speed and can malfunction at any time. 4-5 mounting bolts on top of the pump motor hold the computer module in place. If the ABS light continues on after you switch off the key or you hear a humming braking noise, one of the valve control coils has burned out and has to be replaced right immediately. Search online for car service near me and schedule an appointment with car mechanic.

4. Replace the ABS wheel speed sensor - Look for error codes on the ABS wheel sensor such as C0050, C0046, C0045, C0041, C0040, C0035, and so on. Your car sensors are not plugged in or need to be changed owing to a short circuit, as indicated by the error codes.

5. Check the stator ring - To detect wheel rotation speed, the ABS wheel sensor and the stator ring operate together. The ABS system might be faulty if the stator ring is damaged. Check for a damaged or dislocated stator ring, which might lead in missing teeth and the ABS light coming on. Due to a damaged tooth on the stator ring, the front wheel sensor receives inconsistent signals. The ABS wheel sensor, which resembles a reluctor ring with teeth, sends a separate error number.As the wheel revolves, the teeth pass across the magnetic speed sensor, providing a number in miles per hour. When the controller senses that the wheel isn't moving, it pulses the brake calipers on the wheel. When the signal is inconsistent, the warning ABS light lights, and the ABS system may engage and pulse your brakes at low speeds. Physically inspect the stator ring for missing teeth, which would indicate the lack of a warning light.